- Colour : Clear / Black / White / Grey
- Base : Modified Silane
- Viscosity : Paste
- Min / Max Temp : -40°C – +90°C
- Skinning Time : 10 mins 20°C
A high quality adhesive/sealant suitable for making permanent elastic seals of high strength. It offers excellent primerless adhesion to most common materials such as steel, anodized aluminium, wood, concrete, stone among others.
Warning : Pressurised container: may burst if heated. Causes skin irritation. Causes serious eye irritation. May cause respiratory irritation. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Avoid breathing spray. Wear protective gloves / protective clothing / eye protection / face protection.
If In Eyes : Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Dispose of contents / container in accordance with national regulations.
Contains : Sodium Silicate.
- Ensure surfaces to be bonded and/or sealed are clean and free from grease, dust and any other contamination.
- Where applicable prefill joints with a cross linked Polyethylene foam to give the required joint depth.
- For maximum bond strength prime surfaces with Bondloc Universal Primer.
- Pierce metal seal on the tip of the cartridge and screw on nozzle.
- Cut nozzle to desired size, cutting at a 45° angle.
- Insert cartridge into gun and press out the metal seal at the base of the cartridge.
- Apply the material at the desired rate.
- Smooth the surface of the joint with a spatula or similar tool dipped in water that contains a little detergent.
- Allow to cure.
